VM Audio SRA2200.1 Specifications download pdf (Page 6)

9 10

1. Locate the remote wire on the stereo head unit.

2. Route the remote wire with a wire length that

expands from the stereo head unit all the way to

the amplier’s negative power terminal.

3. Strip both ends of the remote wire by 1/2” to

expose the wire.

4. Connect the remote wire to the stereo’s

remote wire by twisting both wires together, and

insulate the connection well with electrical tape.

5. Connect the other end of the remote wire to

the amplier’s remote REM terminal.

REMOTE

For a good electrical connection and maximum power

transfer, use the same gauge size ground cable as

the power cable. The length of the cable should be

as short as possible and as close to the amplier as

possible.

The remote wire, when connected to the amplier, is

designed to turn on the amplier automatically when

your stereo is turned on.

Consult with the manufacturer’s user guide for your

stereo head unit to locate the remote or turn-on wire,

as some manufacturers might label their amplier

turn-on feature differently.

GROUND

1. Locate a good, non-rusted chassis metal point

in the vehicle.

2. Mark and drill a screw hole with an electric drill

where chassis ground connection is to be made.

3. Use sandpaper to remove paint or rust to

expose the area to bare metal.

4. Strip 1/2” of insulation on both ends of the

ground cable to expose the wires.

5. Connect one end of the ground cable to an

O-ring connector, and tightly fasten the connector

using a sheet metal screw to the chassis metal.

6. Connect the other end of the gound cable to

the amplier’s ground GND terminal.

WARNING! Be aware of gas tanks, gas lines, hydraulic

lines and electrical wiring when drilling mounting holes

to prevent serious or life-threatening injuries.

POWER CONNECTIONS Continued...

1 2 3 4 5 6 7 8 9 10 11 12 13

No comments

VM Audio SRA2200.1 Specifications Page 6